CVE-2023-52750

Published May 21, 2024

Last updated 9 months ago

CVSS medium 5.5

Overview

Description
In the Linux kernel, the following vulnerability has been resolved: arm64: Restrict CPU_BIG_ENDIAN to GNU as or LLVM IAS 15.x or newer Prior to LLVM 15.0.0, LLVM's integrated assembler would incorrectly byte-swap NOP when compiling for big-endian, and the resulting series of bytes happened to match the encoding of FNMADD S21, S30, S0, S0. This went unnoticed until commit: 34f66c4c4d5518c1 ("arm64: Use a positive cpucap for FP/SIMD") Prior to that commit, the kernel would always enable the use of FPSIMD early in boot when __cpu_setup() initialized CPACR_EL1, and so usage of FNMADD within the kernel was not detected, but could result in the corruption of user or kernel FPSIMD state. After that commit, the instructions happen to trap during boot prior to FPSIMD being detected and enabled, e.g. | Unhandled 64-bit el1h sync exception on CPU0, ESR 0x000000001fe00000 -- ASIMD | CPU: 0 PID: 0 Comm: swapper Not tainted 6.6.0-rc3-00013-g34f66c4c4d55 #1 | Hardware name: linux,dummy-virt (DT) | pstate: 400000c9 (nZcv daIF -PAN -UAO -TCO -DIT -SSBS BTYPE=--) | pc : __pi_strcmp+0x1c/0x150 | lr : populate_properties+0xe4/0x254 | sp : ffffd014173d3ad0 | x29: ffffd014173d3af0 x28: fffffbfffddffcb8 x27: 0000000000000000 | x26: 0000000000000058 x25: fffffbfffddfe054 x24: 0000000000000008 | x23: fffffbfffddfe000 x22: fffffbfffddfe000 x21: fffffbfffddfe044 | x20: ffffd014173d3b70 x19: 0000000000000001 x18: 0000000000000005 | x17: 0000000000000010 x16: 0000000000000000 x15: 00000000413e7000 | x14: 0000000000000000 x13: 0000000000001bcc x12: 0000000000000000 | x11: 00000000d00dfeed x10: ffffd414193f2cd0 x9 : 0000000000000000 | x8 : 0101010101010101 x7 : ffffffffffffffc0 x6 : 0000000000000000 | x5 : 0000000000000000 x4 : 0101010101010101 x3 : 000000000000002a | x2 : 0000000000000001 x1 : ffffd014171f2988 x0 : fffffbfffddffcb8 | Kernel panic - not syncing: Unhandled exception | CPU: 0 PID: 0 Comm: swapper Not tainted 6.6.0-rc3-00013-g34f66c4c4d55 #1 | Hardware name: linux,dummy-virt (DT) | Call trace: | dump_backtrace+0xec/0x108 | show_stack+0x18/0x2c | dump_stack_lvl+0x50/0x68 | dump_stack+0x18/0x24 | panic+0x13c/0x340 | el1t_64_irq_handler+0x0/0x1c | el1_abort+0x0/0x5c | el1h_64_sync+0x64/0x68 | __pi_strcmp+0x1c/0x150 | unflatten_dt_nodes+0x1e8/0x2d8 | __unflatten_device_tree+0x5c/0x15c | unflatten_device_tree+0x38/0x50 | setup_arch+0x164/0x1e0 | start_kernel+0x64/0x38c | __primary_switched+0xbc/0xc4 Restrict CONFIG_CPU_BIG_ENDIAN to a known good assembler, which is either GNU as or LLVM's IAS 15.0.0 and newer, which contains the linked commit.
Source
416baaa9-dc9f-4396-8d5f-8c081fb06d67
NVD status
Analyzed
Products
linux_kernel

Risk scores

CVSS 3.1

Type
Primary
Base score
5.5
Impact score
3.6
Exploitability score
1.8
Vector string
CVSS:3.1/AV:L/AC:L/PR:L/UI:N/S:U/C:N/I:N/A:H
Severity
MEDIUM

Weaknesses

nvd@nist.gov
NVD-CWE-noinfo

Social media

Hype score
Not currently trending

Configurations

Related CVEs

  1. In the Linux kernel, the following vulnerability has been resolved: ibmveth: Disable GSO for packets with small MSS Some physical adapters on Power systems do not support segmentation offload when the MSS is less than 224 bytes. Attempting to send such packets causes the adapter to freeze, stopping all traffic until manually reset. Implement ndo_features_check to disable GSO for packets with small MSS values. The network stack will perform software segmentation instead. The 224-byte minimum matches ibmvnic commit <f10b09ef687f> ("ibmvnic: Enforce stronger sanity checks on GSO packets") which uses the same physical adapters in SEA configurations. The issue occurs specifically when the hardware attempts to perform segmentation (gso_segs > 1) with a small MSS. Single-segment GSO packets (gso_segs == 1) do not trigger the problematic LSO code path and are transmitted normally without segmentation. Add an ndo_features_check callback to disable GSO when MSS < 224 bytes. Also call vlan_features_check() to ensure proper handling of VLAN packets, particularly QinQ (802.1ad) configurations where the hardware parser may not support certain offload features. Validated using iptables to force small MSS values. Without the fix, the adapter freezes. With the fix, packets are segmented in software and transmission succeeds. Comprehensive regression testing completedd (MSS tests, performance, stability).•CVE-2026-46273
  2. In the Linux kernel, the following vulnerability has been resolved: coresight: tmc-etr: Fix race condition between sysfs and perf mode When trying to run perf and sysfs mode simultaneously, the WARN_ON() in tmc_etr_enable_hw() is triggered sometimes: WARNING: CPU: 42 PID: 3911571 at drivers/hwtracing/coresight/coresight-tmc-etr.c:1060 tmc_etr_enable_hw+0xc0/0xd8 [coresight_tmc] [..snip..] Call trace: tmc_etr_enable_hw+0xc0/0xd8 [coresight_tmc] (P) tmc_enable_etr_sink+0x11c/0x250 [coresight_tmc] (L) tmc_enable_etr_sink+0x11c/0x250 [coresight_tmc] coresight_enable_path+0x1c8/0x218 [coresight] coresight_enable_sysfs+0xa4/0x228 [coresight] enable_source_store+0x58/0xa8 [coresight] dev_attr_store+0x20/0x40 sysfs_kf_write+0x4c/0x68 kernfs_fop_write_iter+0x120/0x1b8 vfs_write+0x2c8/0x388 ksys_write+0x74/0x108 __arm64_sys_write+0x24/0x38 el0_svc_common.constprop.0+0x64/0x148 do_el0_svc+0x24/0x38 el0_svc+0x3c/0x130 el0t_64_sync_handler+0xc8/0xd0 el0t_64_sync+0x1ac/0x1b0 ---[ end trace 0000000000000000 ]--- Since the enablement of sysfs mode is separeted into two critical regions, one for sysfs buffer allocation and another for hardware enablement, it's possible to race with the perf mode. Fix this by double check whether the perf mode's been used before enabling the hardware in sysfs mode. mode: [sysfs mode] [perf mode] tmc_etr_get_sysfs_buffer() spin_lock(&drvdata->spinlock) [sysfs buffer allocation] spin_unlock(&drvdata->spinlock) spin_lock(&drvdata->spinlock) tmc_etr_enable_hw() drvdata->etr_buf = etr_perf->etr_buf spin_unlock(&drvdata->spinlock) spin_lock(&drvdata->spinlock) tmc_etr_enable_hw() WARN_ON(drvdata->etr_buf) // WARN sicne etr_buf initialized at the perf side spin_unlock(&drvdata->spinlock) With this fix, we retain the check for CS_MODE_PERF in get_etr_sysfs_buf. This ensures we verify whether the perf mode's already running before we actually allocate the buffer. Then we can save the time of allocating/freeing the sysfs buffer if race with the perf mode.•CVE-2026-46272
  3. In the Linux kernel, the following vulnerability has been resolved: wifi: ath12k: do WoW offloads only on primary link In case of multi-link connection, WCN7850 firmware crashes due to WoW offloads enabled on both primary and secondary links. Change to do it only on primary link to fix it. Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.1.c5-00284-QCAHMTSWPL_V1.0_V2.0_SILICONZ-1•CVE-2026-46271
  4. In the Linux kernel, the following vulnerability has been resolved: power: supply: rt9455: Fix use-after-free in power_supply_changed() Using the `devm_` variant for requesting IRQ _before_ the `devm_` variant for allocating/registering the `power_supply` handle, means that the `power_supply` handle will be deallocated/unregistered _before_ the interrupt handler (since `devm_` naturally deallocates in reverse allocation order). This means that during removal, there is a race condition where an interrupt can fire just _after_ the `power_supply` handle has been freed, *but* just _before_ the corresponding unregistration of the IRQ handler has run. This will lead to the IRQ handler calling `power_supply_changed()` with a freed `power_supply` handle. Which usually crashes the system or otherwise silently corrupts the memory... Note that there is a similar situation which can also happen during `probe()`; the possibility of an interrupt firing _before_ registering the `power_supply` handle. This would then lead to the nasty situation of using the `power_supply` handle *uninitialized* in `power_supply_changed()`. Fix this racy use-after-free by making sure the IRQ is requested _after_ the registration of the `power_supply` handle.•CVE-2026-46270
  5. In the Linux kernel, the following vulnerability has been resolved: pinctrl: canaan: k230: Fix NULL pointer dereference when parsing devicetree When probing the k230 pinctrl driver, the kernel triggers a NULL pointer dereference. The crash trace showed: [ 0.732084] Unable to handle kernel NULL pointer dereference at virtual address 0000000000000068 [ 0.740737] ... [ 0.776296] epc : k230_pinctrl_probe+0x1be/0x4fc In k230_pinctrl_parse_functions(), we attempt to retrieve the device pointer via info->pctl_dev->dev, but info->pctl_dev is only initialized after k230_pinctrl_parse_dt() completes. At the time of DT parsing, info->pctl_dev is still NULL, leading to the invalid dereference of info->pctl_dev->dev. Use the already available device pointer from platform_device instead of accessing through uninitialized pctl_dev.•CVE-2026-46269

References

Sources include official advisories and independent security research.