CVE-2024-53190

Published Dec 27, 2024

Last updated 7 months ago

CVSS medium 5.5

Overview

Description
In the Linux kernel, the following vulnerability has been resolved: wifi: rtlwifi: Drastically reduce the attempts to read efuse in case of failures Syzkaller reported a hung task with uevent_show() on stack trace. That specific issue was addressed by another commit [0], but even with that fix applied (for example, running v6.12-rc5) we face another type of hung task that comes from the same reproducer [1]. By investigating that, we could narrow it to the following path: (a) Syzkaller emulates a Realtek USB WiFi adapter using raw-gadget and dummy_hcd infrastructure. (b) During the probe of rtl8192cu, the driver ends-up performing an efuse read procedure (which is related to EEPROM load IIUC), and here lies the issue: the function read_efuse() calls read_efuse_byte() many times, as loop iterations depending on the efuse size (in our example, 512 in total). This procedure for reading efuse bytes relies in a loop that performs an I/O read up to *10k* times in case of failures. We measured the time of the loop inside read_efuse_byte() alone, and in this reproducer (which involves the dummy_hcd emulation layer), it takes 15 seconds each. As a consequence, we have the driver stuck in its probe routine for big time, exposing a stack trace like below if we attempt to reboot the system, for example: task:kworker/0:3 state:D stack:0 pid:662 tgid:662 ppid:2 flags:0x00004000 Workqueue: usb_hub_wq hub_event Call Trace: __schedule+0xe22/0xeb6 schedule_timeout+0xe7/0x132 __wait_for_common+0xb5/0x12e usb_start_wait_urb+0xc5/0x1ef ? usb_alloc_urb+0x95/0xa4 usb_control_msg+0xff/0x184 _usbctrl_vendorreq_sync+0xa0/0x161 _usb_read_sync+0xb3/0xc5 read_efuse_byte+0x13c/0x146 read_efuse+0x351/0x5f0 efuse_read_all_map+0x42/0x52 rtl_efuse_shadow_map_update+0x60/0xef rtl_get_hwinfo+0x5d/0x1c2 rtl92cu_read_eeprom_info+0x10a/0x8d5 ? rtl92c_read_chip_version+0x14f/0x17e rtl_usb_probe+0x323/0x851 usb_probe_interface+0x278/0x34b really_probe+0x202/0x4a4 __driver_probe_device+0x166/0x1b2 driver_probe_device+0x2f/0xd8 [...] We propose hereby to drastically reduce the attempts of doing the I/O reads in case of failures, restricted to USB devices (given that they're inherently slower than PCIe ones). By retrying up to 10 times (instead of 10000), we got reponsiveness in the reproducer, while seems reasonable to believe that there's no sane USB device implementation in the field requiring this amount of retries at every I/O read in order to properly work. Based on that assumption, it'd be good to have it backported to stable but maybe not since driver implementation (the 10k number comes from day 0), perhaps up to 6.x series makes sense. [0] Commit 15fffc6a5624 ("driver core: Fix uevent_show() vs driver detach race") [1] A note about that: this syzkaller report presents multiple reproducers that differs by the type of emulated USB device. For this specific case, check the entry from 2024/08/08 06:23 in the list of crashes; the C repro is available at https://syzkaller.appspot.com/text?tag=ReproC&x=1521fc83980000.
Source
416baaa9-dc9f-4396-8d5f-8c081fb06d67
NVD status
Modified
Products
linux_kernel

Risk scores

CVSS 3.1

Type
Primary
Base score
5.5
Impact score
3.6
Exploitability score
1.8
Vector string
CVSS:3.1/AV:L/AC:L/PR:L/UI:N/S:U/C:N/I:N/A:H
Severity
MEDIUM

Weaknesses

nvd@nist.gov
NVD-CWE-noinfo

Social media

Hype score
Not currently trending

Configurations

Related CVEs

  1. In the Linux kernel, the following vulnerability has been resolved: ibmveth: Disable GSO for packets with small MSS Some physical adapters on Power systems do not support segmentation offload when the MSS is less than 224 bytes. Attempting to send such packets causes the adapter to freeze, stopping all traffic until manually reset. Implement ndo_features_check to disable GSO for packets with small MSS values. The network stack will perform software segmentation instead. The 224-byte minimum matches ibmvnic commit <f10b09ef687f> ("ibmvnic: Enforce stronger sanity checks on GSO packets") which uses the same physical adapters in SEA configurations. The issue occurs specifically when the hardware attempts to perform segmentation (gso_segs > 1) with a small MSS. Single-segment GSO packets (gso_segs == 1) do not trigger the problematic LSO code path and are transmitted normally without segmentation. Add an ndo_features_check callback to disable GSO when MSS < 224 bytes. Also call vlan_features_check() to ensure proper handling of VLAN packets, particularly QinQ (802.1ad) configurations where the hardware parser may not support certain offload features. Validated using iptables to force small MSS values. Without the fix, the adapter freezes. With the fix, packets are segmented in software and transmission succeeds. Comprehensive regression testing completedd (MSS tests, performance, stability).•CVE-2026-46273
  2. In the Linux kernel, the following vulnerability has been resolved: coresight: tmc-etr: Fix race condition between sysfs and perf mode When trying to run perf and sysfs mode simultaneously, the WARN_ON() in tmc_etr_enable_hw() is triggered sometimes: WARNING: CPU: 42 PID: 3911571 at drivers/hwtracing/coresight/coresight-tmc-etr.c:1060 tmc_etr_enable_hw+0xc0/0xd8 [coresight_tmc] [..snip..] Call trace: tmc_etr_enable_hw+0xc0/0xd8 [coresight_tmc] (P) tmc_enable_etr_sink+0x11c/0x250 [coresight_tmc] (L) tmc_enable_etr_sink+0x11c/0x250 [coresight_tmc] coresight_enable_path+0x1c8/0x218 [coresight] coresight_enable_sysfs+0xa4/0x228 [coresight] enable_source_store+0x58/0xa8 [coresight] dev_attr_store+0x20/0x40 sysfs_kf_write+0x4c/0x68 kernfs_fop_write_iter+0x120/0x1b8 vfs_write+0x2c8/0x388 ksys_write+0x74/0x108 __arm64_sys_write+0x24/0x38 el0_svc_common.constprop.0+0x64/0x148 do_el0_svc+0x24/0x38 el0_svc+0x3c/0x130 el0t_64_sync_handler+0xc8/0xd0 el0t_64_sync+0x1ac/0x1b0 ---[ end trace 0000000000000000 ]--- Since the enablement of sysfs mode is separeted into two critical regions, one for sysfs buffer allocation and another for hardware enablement, it's possible to race with the perf mode. Fix this by double check whether the perf mode's been used before enabling the hardware in sysfs mode. mode: [sysfs mode] [perf mode] tmc_etr_get_sysfs_buffer() spin_lock(&drvdata->spinlock) [sysfs buffer allocation] spin_unlock(&drvdata->spinlock) spin_lock(&drvdata->spinlock) tmc_etr_enable_hw() drvdata->etr_buf = etr_perf->etr_buf spin_unlock(&drvdata->spinlock) spin_lock(&drvdata->spinlock) tmc_etr_enable_hw() WARN_ON(drvdata->etr_buf) // WARN sicne etr_buf initialized at the perf side spin_unlock(&drvdata->spinlock) With this fix, we retain the check for CS_MODE_PERF in get_etr_sysfs_buf. This ensures we verify whether the perf mode's already running before we actually allocate the buffer. Then we can save the time of allocating/freeing the sysfs buffer if race with the perf mode.•CVE-2026-46272
  3. In the Linux kernel, the following vulnerability has been resolved: wifi: ath12k: do WoW offloads only on primary link In case of multi-link connection, WCN7850 firmware crashes due to WoW offloads enabled on both primary and secondary links. Change to do it only on primary link to fix it. Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.1.c5-00284-QCAHMTSWPL_V1.0_V2.0_SILICONZ-1•CVE-2026-46271
  4. In the Linux kernel, the following vulnerability has been resolved: power: supply: rt9455: Fix use-after-free in power_supply_changed() Using the `devm_` variant for requesting IRQ _before_ the `devm_` variant for allocating/registering the `power_supply` handle, means that the `power_supply` handle will be deallocated/unregistered _before_ the interrupt handler (since `devm_` naturally deallocates in reverse allocation order). This means that during removal, there is a race condition where an interrupt can fire just _after_ the `power_supply` handle has been freed, *but* just _before_ the corresponding unregistration of the IRQ handler has run. This will lead to the IRQ handler calling `power_supply_changed()` with a freed `power_supply` handle. Which usually crashes the system or otherwise silently corrupts the memory... Note that there is a similar situation which can also happen during `probe()`; the possibility of an interrupt firing _before_ registering the `power_supply` handle. This would then lead to the nasty situation of using the `power_supply` handle *uninitialized* in `power_supply_changed()`. Fix this racy use-after-free by making sure the IRQ is requested _after_ the registration of the `power_supply` handle.•CVE-2026-46270
  5. In the Linux kernel, the following vulnerability has been resolved: pinctrl: canaan: k230: Fix NULL pointer dereference when parsing devicetree When probing the k230 pinctrl driver, the kernel triggers a NULL pointer dereference. The crash trace showed: [ 0.732084] Unable to handle kernel NULL pointer dereference at virtual address 0000000000000068 [ 0.740737] ... [ 0.776296] epc : k230_pinctrl_probe+0x1be/0x4fc In k230_pinctrl_parse_functions(), we attempt to retrieve the device pointer via info->pctl_dev->dev, but info->pctl_dev is only initialized after k230_pinctrl_parse_dt() completes. At the time of DT parsing, info->pctl_dev is still NULL, leading to the invalid dereference of info->pctl_dev->dev. Use the already available device pointer from platform_device instead of accessing through uninitialized pctl_dev.•CVE-2026-46269

References

Sources include official advisories and independent security research.