CVE-2025-37964

Published May 20, 2025

Last updated 4 months ago

CVSS medium 5.5

Overview

Description
In the Linux kernel, the following vulnerability has been resolved: x86/mm: Eliminate window where TLB flushes may be inadvertently skipped tl;dr: There is a window in the mm switching code where the new CR3 is set and the CPU should be getting TLB flushes for the new mm. But should_flush_tlb() has a bug and suppresses the flush. Fix it by widening the window where should_flush_tlb() sends an IPI. Long Version: === History === There were a few things leading up to this. First, updating mm_cpumask() was observed to be too expensive, so it was made lazier. But being lazy caused too many unnecessary IPIs to CPUs due to the now-lazy mm_cpumask(). So code was added to cull mm_cpumask() periodically[2]. But that culling was a bit too aggressive and skipped sending TLB flushes to CPUs that need them. So here we are again. === Problem === The too-aggressive code in should_flush_tlb() strikes in this window: // Turn on IPIs for this CPU/mm combination, but only // if should_flush_tlb() agrees: cpumask_set_cpu(cpu, mm_cpumask(next)); next_tlb_gen = atomic64_read(&next->context.tlb_gen); choose_new_asid(next, next_tlb_gen, &new_asid, &need_flush); load_new_mm_cr3(need_flush); // ^ After 'need_flush' is set to false, IPIs *MUST* // be sent to this CPU and not be ignored. this_cpu_write(cpu_tlbstate.loaded_mm, next); // ^ Not until this point does should_flush_tlb() // become true! should_flush_tlb() will suppress TLB flushes between load_new_mm_cr3() and writing to 'loaded_mm', which is a window where they should not be suppressed. Whoops. === Solution === Thankfully, the fuzzy "just about to write CR3" window is already marked with loaded_mm==LOADED_MM_SWITCHING. Simply checking for that state in should_flush_tlb() is sufficient to ensure that the CPU is targeted with an IPI. This will cause more TLB flush IPIs. But the window is relatively small and I do not expect this to cause any kind of measurable performance impact. Update the comment where LOADED_MM_SWITCHING is written since it grew yet another user. Peter Z also raised a concern that should_flush_tlb() might not observe 'loaded_mm' and 'is_lazy' in the same order that switch_mm_irqs_off() writes them. Add a barrier to ensure that they are observed in the order they are written.
Source
416baaa9-dc9f-4396-8d5f-8c081fb06d67
NVD status
Analyzed
Products
linux_kernel, debian_linux

Risk scores

CVSS 3.1

Type
Primary
Base score
5.5
Impact score
3.6
Exploitability score
1.8
Vector string
CVSS:3.1/AV:L/AC:L/PR:L/UI:N/S:U/C:N/I:N/A:H
Severity
MEDIUM

Weaknesses

nvd@nist.gov
NVD-CWE-noinfo

Social media

Hype score
Not currently trending

Configurations

Related CVEs

  1. In the Linux kernel, the following vulnerability has been resolved: net: usb: cdc_ncm: add ndpoffset to NDP32 nframes bounds check The same bounds-check bug fixed for NDP16 in the previous patch also exists in cdc_ncm_rx_verify_ndp32(). The DPE array size is validated against the total skb length without accounting for ndpoffset, allowing out-of-bounds reads when the NDP32 is placed near the end of the NTB. Add ndpoffset to the nframes bounds check and use struct_size_t() to express the NDP-plus-DPE-array size more clearly. Compile-tested only.•CVE-2026-23447
  2. In the Linux kernel, the following vulnerability has been resolved: net: usb: aqc111: Do not perform PM inside suspend callback syzbot reports "task hung in rpm_resume" This is caused by aqc111_suspend calling the PM variant of its write_cmd routine. The simplified call trace looks like this: rpm_suspend() usb_suspend_both() - here udev->dev.power.runtime_status == RPM_SUSPENDING aqc111_suspend() - called for the usb device interface aqc111_write32_cmd() usb_autopm_get_interface() pm_runtime_resume_and_get() rpm_resume() - here we call rpm_resume() on our parent rpm_resume() - Here we wait for a status change that will never happen. At this point we block another task which holds rtnl_lock and locks up the whole networking stack. Fix this by replacing the write_cmd calls with their _nopm variants•CVE-2026-23446
  3. In the Linux kernel, the following vulnerability has been resolved: igc: fix page fault in XDP TX timestamps handling If an XDP application that requested TX timestamping is shutting down while the link of the interface in use is still up the following kernel splat is reported: [ 883.803618] [ T1554] BUG: unable to handle page fault for address: ffffcfb6200fd008 ... [ 883.803650] [ T1554] Call Trace: [ 883.803652] [ T1554] <TASK> [ 883.803654] [ T1554] igc_ptp_tx_tstamp_event+0xdf/0x160 [igc] [ 883.803660] [ T1554] igc_tsync_interrupt+0x2d5/0x300 [igc] ... During shutdown of the TX ring the xsk_meta pointers are left behind, so that the IRQ handler is trying to touch them. This issue is now being fixed by cleaning up the stale xsk meta data on TX shutdown. TX timestamps on other queues remain unaffected.•CVE-2026-23445
  4. In the Linux kernel, the following vulnerability has been resolved: wifi: mac80211: always free skb on ieee80211_tx_prepare_skb() failure ieee80211_tx_prepare_skb() has three error paths, but only two of them free the skb. The first error path (ieee80211_tx_prepare() returning TX_DROP) does not free it, while invoke_tx_handlers() failure and the fragmentation check both do. Add kfree_skb() to the first error path so all three are consistent, and remove the now-redundant frees in callers (ath9k, mt76, mac80211_hwsim) to avoid double-free. Document the skb ownership guarantee in the function's kdoc.•CVE-2026-23444
  5. In the Linux kernel, the following vulnerability has been resolved: ACPI: processor: Fix previous acpi_processor_errata_piix4() fix After commi f132e089fe89 ("ACPI: processor: Fix NULL-pointer dereference in acpi_processor_errata_piix4()"), device pointers may be dereferenced after dropping references to the device objects pointed to by them, which may cause a use-after-free to occur. Moreover, debug messages about enabling the errata may be printed if the errata flags corresponding to them are unset. Address all of these issues by moving message printing to the points in the code where the errata flags are set.•CVE-2026-23443

References

Sources include official advisories and independent security research.