CVE-2025-38040

Published Jun 18, 2025

Last updated 6 months ago

CVSS medium 5.5

Overview

Description
In the Linux kernel, the following vulnerability has been resolved: serial: mctrl_gpio: split disable_ms into sync and no_sync APIs The following splat has been observed on a SAMA5D27 platform using atmel_serial: BUG: sleeping function called from invalid context at kernel/irq/manage.c:738 in_atomic(): 1, irqs_disabled(): 128, non_block: 0, pid: 27, name: kworker/u5:0 preempt_count: 1, expected: 0 INFO: lockdep is turned off. irq event stamp: 0 hardirqs last enabled at (0): [<00000000>] 0x0 hardirqs last disabled at (0): [<c01588f0>] copy_process+0x1c4c/0x7bec softirqs last enabled at (0): [<c0158944>] copy_process+0x1ca0/0x7bec softirqs last disabled at (0): [<00000000>] 0x0 CPU: 0 UID: 0 PID: 27 Comm: kworker/u5:0 Not tainted 6.13.0-rc7+ #74 Hardware name: Atmel SAMA5 Workqueue: hci0 hci_power_on [bluetooth] Call trace: unwind_backtrace from show_stack+0x18/0x1c show_stack from dump_stack_lvl+0x44/0x70 dump_stack_lvl from __might_resched+0x38c/0x598 __might_resched from disable_irq+0x1c/0x48 disable_irq from mctrl_gpio_disable_ms+0x74/0xc0 mctrl_gpio_disable_ms from atmel_disable_ms.part.0+0x80/0x1f4 atmel_disable_ms.part.0 from atmel_set_termios+0x764/0x11e8 atmel_set_termios from uart_change_line_settings+0x15c/0x994 uart_change_line_settings from uart_set_termios+0x2b0/0x668 uart_set_termios from tty_set_termios+0x600/0x8ec tty_set_termios from ttyport_set_flow_control+0x188/0x1e0 ttyport_set_flow_control from wilc_setup+0xd0/0x524 [hci_wilc] wilc_setup [hci_wilc] from hci_dev_open_sync+0x330/0x203c [bluetooth] hci_dev_open_sync [bluetooth] from hci_dev_do_open+0x40/0xb0 [bluetooth] hci_dev_do_open [bluetooth] from hci_power_on+0x12c/0x664 [bluetooth] hci_power_on [bluetooth] from process_one_work+0x998/0x1a38 process_one_work from worker_thread+0x6e0/0xfb4 worker_thread from kthread+0x3d4/0x484 kthread from ret_from_fork+0x14/0x28 This warning is emitted when trying to toggle, at the highest level, some flow control (with serdev_device_set_flow_control) in a device driver. At the lowest level, the atmel_serial driver is using serial_mctrl_gpio lib to enable/disable the corresponding IRQs accordingly. The warning emitted by CONFIG_DEBUG_ATOMIC_SLEEP is due to disable_irq (called in mctrl_gpio_disable_ms) being possibly called in some atomic context (some tty drivers perform modem lines configuration in regions protected by port lock). Split mctrl_gpio_disable_ms into two differents APIs, a non-blocking one and a blocking one. Replace mctrl_gpio_disable_ms calls with the relevant version depending on whether the call is protected by some port lock.
Source
416baaa9-dc9f-4396-8d5f-8c081fb06d67
NVD status
Analyzed
Products
linux_kernel, debian_linux

Risk scores

CVSS 3.1

Type
Primary
Base score
5.5
Impact score
3.6
Exploitability score
1.8
Vector string
CVSS:3.1/AV:L/AC:L/PR:L/UI:N/S:U/C:N/I:N/A:H
Severity
MEDIUM

Weaknesses

nvd@nist.gov
NVD-CWE-noinfo

Social media

Hype score
Not currently trending

Configurations

Related CVEs

  1. Memory Allocation with Excessive Size Value vulnerability in Apache HTTP Server's mod_http leads to denial of service via malicious HTTP requests. This issue affects Apache HTTP Server: from 2.4.17 through 2.4.67.•CVE-2026-49975
  2. In the Linux kernel, the following vulnerability has been resolved: ibmveth: Disable GSO for packets with small MSS Some physical adapters on Power systems do not support segmentation offload when the MSS is less than 224 bytes. Attempting to send such packets causes the adapter to freeze, stopping all traffic until manually reset. Implement ndo_features_check to disable GSO for packets with small MSS values. The network stack will perform software segmentation instead. The 224-byte minimum matches ibmvnic commit <f10b09ef687f> ("ibmvnic: Enforce stronger sanity checks on GSO packets") which uses the same physical adapters in SEA configurations. The issue occurs specifically when the hardware attempts to perform segmentation (gso_segs > 1) with a small MSS. Single-segment GSO packets (gso_segs == 1) do not trigger the problematic LSO code path and are transmitted normally without segmentation. Add an ndo_features_check callback to disable GSO when MSS < 224 bytes. Also call vlan_features_check() to ensure proper handling of VLAN packets, particularly QinQ (802.1ad) configurations where the hardware parser may not support certain offload features. Validated using iptables to force small MSS values. Without the fix, the adapter freezes. With the fix, packets are segmented in software and transmission succeeds. Comprehensive regression testing completedd (MSS tests, performance, stability).•CVE-2026-46273
  3. In the Linux kernel, the following vulnerability has been resolved: coresight: tmc-etr: Fix race condition between sysfs and perf mode When trying to run perf and sysfs mode simultaneously, the WARN_ON() in tmc_etr_enable_hw() is triggered sometimes: WARNING: CPU: 42 PID: 3911571 at drivers/hwtracing/coresight/coresight-tmc-etr.c:1060 tmc_etr_enable_hw+0xc0/0xd8 [coresight_tmc] [..snip..] Call trace: tmc_etr_enable_hw+0xc0/0xd8 [coresight_tmc] (P) tmc_enable_etr_sink+0x11c/0x250 [coresight_tmc] (L) tmc_enable_etr_sink+0x11c/0x250 [coresight_tmc] coresight_enable_path+0x1c8/0x218 [coresight] coresight_enable_sysfs+0xa4/0x228 [coresight] enable_source_store+0x58/0xa8 [coresight] dev_attr_store+0x20/0x40 sysfs_kf_write+0x4c/0x68 kernfs_fop_write_iter+0x120/0x1b8 vfs_write+0x2c8/0x388 ksys_write+0x74/0x108 __arm64_sys_write+0x24/0x38 el0_svc_common.constprop.0+0x64/0x148 do_el0_svc+0x24/0x38 el0_svc+0x3c/0x130 el0t_64_sync_handler+0xc8/0xd0 el0t_64_sync+0x1ac/0x1b0 ---[ end trace 0000000000000000 ]--- Since the enablement of sysfs mode is separeted into two critical regions, one for sysfs buffer allocation and another for hardware enablement, it's possible to race with the perf mode. Fix this by double check whether the perf mode's been used before enabling the hardware in sysfs mode. mode: [sysfs mode] [perf mode] tmc_etr_get_sysfs_buffer() spin_lock(&drvdata->spinlock) [sysfs buffer allocation] spin_unlock(&drvdata->spinlock) spin_lock(&drvdata->spinlock) tmc_etr_enable_hw() drvdata->etr_buf = etr_perf->etr_buf spin_unlock(&drvdata->spinlock) spin_lock(&drvdata->spinlock) tmc_etr_enable_hw() WARN_ON(drvdata->etr_buf) // WARN sicne etr_buf initialized at the perf side spin_unlock(&drvdata->spinlock) With this fix, we retain the check for CS_MODE_PERF in get_etr_sysfs_buf. This ensures we verify whether the perf mode's already running before we actually allocate the buffer. Then we can save the time of allocating/freeing the sysfs buffer if race with the perf mode.•CVE-2026-46272
  4. In the Linux kernel, the following vulnerability has been resolved: wifi: ath12k: do WoW offloads only on primary link In case of multi-link connection, WCN7850 firmware crashes due to WoW offloads enabled on both primary and secondary links. Change to do it only on primary link to fix it. Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.1.c5-00284-QCAHMTSWPL_V1.0_V2.0_SILICONZ-1•CVE-2026-46271
  5. In the Linux kernel, the following vulnerability has been resolved: power: supply: rt9455: Fix use-after-free in power_supply_changed() Using the `devm_` variant for requesting IRQ _before_ the `devm_` variant for allocating/registering the `power_supply` handle, means that the `power_supply` handle will be deallocated/unregistered _before_ the interrupt handler (since `devm_` naturally deallocates in reverse allocation order). This means that during removal, there is a race condition where an interrupt can fire just _after_ the `power_supply` handle has been freed, *but* just _before_ the corresponding unregistration of the IRQ handler has run. This will lead to the IRQ handler calling `power_supply_changed()` with a freed `power_supply` handle. Which usually crashes the system or otherwise silently corrupts the memory... Note that there is a similar situation which can also happen during `probe()`; the possibility of an interrupt firing _before_ registering the `power_supply` handle. This would then lead to the nasty situation of using the `power_supply` handle *uninitialized* in `power_supply_changed()`. Fix this racy use-after-free by making sure the IRQ is requested _after_ the registration of the `power_supply` handle.•CVE-2026-46270

References

Sources include official advisories and independent security research.