CVE-2025-71162

Published Jan 25, 2026

Last updated 2 months ago

CVSS high 7.8

Overview

Description
In the Linux kernel, the following vulnerability has been resolved: dmaengine: tegra-adma: Fix use-after-free A use-after-free bug exists in the Tegra ADMA driver when audio streams are terminated, particularly during XRUN conditions. The issue occurs when the DMA buffer is freed by tegra_adma_terminate_all() before the vchan completion tasklet finishes accessing it. The race condition follows this sequence: 1. DMA transfer completes, triggering an interrupt that schedules the completion tasklet (tasklet has not executed yet) 2. Audio playback stops, calling tegra_adma_terminate_all() which frees the DMA buffer memory via kfree() 3. The scheduled tasklet finally executes, calling vchan_complete() which attempts to access the already-freed memory Since tasklets can execute at any time after being scheduled, there is no guarantee that the buffer will remain valid when vchan_complete() runs. Fix this by properly synchronizing the virtual channel completion: - Calling vchan_terminate_vdesc() in tegra_adma_stop() to mark the descriptors as terminated instead of freeing the descriptor. - Add the callback tegra_adma_synchronize() that calls vchan_synchronize() which kills any pending tasklets and frees any terminated descriptors. Crash logs: [ 337.427523] BUG: KASAN: use-after-free in vchan_complete+0x124/0x3b0 [ 337.427544] Read of size 8 at addr ffff000132055428 by task swapper/0/0 [ 337.427562] Call trace: [ 337.427564] dump_backtrace+0x0/0x320 [ 337.427571] show_stack+0x20/0x30 [ 337.427575] dump_stack_lvl+0x68/0x84 [ 337.427584] print_address_description.constprop.0+0x74/0x2b8 [ 337.427590] kasan_report+0x1f4/0x210 [ 337.427598] __asan_load8+0xa0/0xd0 [ 337.427603] vchan_complete+0x124/0x3b0 [ 337.427609] tasklet_action_common.constprop.0+0x190/0x1d0 [ 337.427617] tasklet_action+0x30/0x40 [ 337.427623] __do_softirq+0x1a0/0x5c4 [ 337.427628] irq_exit+0x110/0x140 [ 337.427633] handle_domain_irq+0xa4/0xe0 [ 337.427640] gic_handle_irq+0x64/0x160 [ 337.427644] call_on_irq_stack+0x20/0x4c [ 337.427649] do_interrupt_handler+0x7c/0x90 [ 337.427654] el1_interrupt+0x30/0x80 [ 337.427659] el1h_64_irq_handler+0x18/0x30 [ 337.427663] el1h_64_irq+0x7c/0x80 [ 337.427667] cpuidle_enter_state+0xe4/0x540 [ 337.427674] cpuidle_enter+0x54/0x80 [ 337.427679] do_idle+0x2e0/0x380 [ 337.427685] cpu_startup_entry+0x2c/0x70 [ 337.427690] rest_init+0x114/0x130 [ 337.427695] arch_call_rest_init+0x18/0x24 [ 337.427702] start_kernel+0x380/0x3b4 [ 337.427706] __primary_switched+0xc0/0xc8
Source
416baaa9-dc9f-4396-8d5f-8c081fb06d67
NVD status
Analyzed
Products
linux_kernel

Risk scores

CVSS 3.1

Type
Primary
Base score
7.8
Impact score
5.9
Exploitability score
1.8
Vector string
CVSS:3.1/AV:L/AC:L/PR:L/UI:N/S:U/C:H/I:H/A:H
Severity
HIGH

Weaknesses

nvd@nist.gov
CWE-416

Social media

Hype score
Not currently trending

  1. There is a new vulnerability with elevated criticality in Linux Kernel (CVE-2025-71162) https://t.co/YjQJs9mG8j

    @vuldb

    25 Jan 2026

    71 Impressions

    0 Retweets

    0 Likes

    0 Bookmarks

    0 Replies

    0 Quotes

Configurations

Related CVEs

  1. In the Linux kernel, the following vulnerability has been resolved: net: usb: cdc_ncm: add ndpoffset to NDP32 nframes bounds check The same bounds-check bug fixed for NDP16 in the previous patch also exists in cdc_ncm_rx_verify_ndp32(). The DPE array size is validated against the total skb length without accounting for ndpoffset, allowing out-of-bounds reads when the NDP32 is placed near the end of the NTB. Add ndpoffset to the nframes bounds check and use struct_size_t() to express the NDP-plus-DPE-array size more clearly. Compile-tested only.•CVE-2026-23447
  2. In the Linux kernel, the following vulnerability has been resolved: net: usb: aqc111: Do not perform PM inside suspend callback syzbot reports "task hung in rpm_resume" This is caused by aqc111_suspend calling the PM variant of its write_cmd routine. The simplified call trace looks like this: rpm_suspend() usb_suspend_both() - here udev->dev.power.runtime_status == RPM_SUSPENDING aqc111_suspend() - called for the usb device interface aqc111_write32_cmd() usb_autopm_get_interface() pm_runtime_resume_and_get() rpm_resume() - here we call rpm_resume() on our parent rpm_resume() - Here we wait for a status change that will never happen. At this point we block another task which holds rtnl_lock and locks up the whole networking stack. Fix this by replacing the write_cmd calls with their _nopm variants•CVE-2026-23446
  3. In the Linux kernel, the following vulnerability has been resolved: igc: fix page fault in XDP TX timestamps handling If an XDP application that requested TX timestamping is shutting down while the link of the interface in use is still up the following kernel splat is reported: [ 883.803618] [ T1554] BUG: unable to handle page fault for address: ffffcfb6200fd008 ... [ 883.803650] [ T1554] Call Trace: [ 883.803652] [ T1554] <TASK> [ 883.803654] [ T1554] igc_ptp_tx_tstamp_event+0xdf/0x160 [igc] [ 883.803660] [ T1554] igc_tsync_interrupt+0x2d5/0x300 [igc] ... During shutdown of the TX ring the xsk_meta pointers are left behind, so that the IRQ handler is trying to touch them. This issue is now being fixed by cleaning up the stale xsk meta data on TX shutdown. TX timestamps on other queues remain unaffected.•CVE-2026-23445
  4. In the Linux kernel, the following vulnerability has been resolved: wifi: mac80211: always free skb on ieee80211_tx_prepare_skb() failure ieee80211_tx_prepare_skb() has three error paths, but only two of them free the skb. The first error path (ieee80211_tx_prepare() returning TX_DROP) does not free it, while invoke_tx_handlers() failure and the fragmentation check both do. Add kfree_skb() to the first error path so all three are consistent, and remove the now-redundant frees in callers (ath9k, mt76, mac80211_hwsim) to avoid double-free. Document the skb ownership guarantee in the function's kdoc.•CVE-2026-23444
  5. In the Linux kernel, the following vulnerability has been resolved: ACPI: processor: Fix previous acpi_processor_errata_piix4() fix After commi f132e089fe89 ("ACPI: processor: Fix NULL-pointer dereference in acpi_processor_errata_piix4()"), device pointers may be dereferenced after dropping references to the device objects pointed to by them, which may cause a use-after-free to occur. Moreover, debug messages about enabling the errata may be printed if the errata flags corresponding to them are unset. Address all of these issues by moving message printing to the points in the code where the errata flags are set.•CVE-2026-23443

References

Sources include official advisories and independent security research.