CVEs

In the Linux kernel, the following vulnerability has been resolved: ipvs: stop estimator after disabled calc phase IPVS estimator kthread 0 starts with zeroed chain and tick limits until its initial calculation phase completes. If network namespace teardown clears ipvs->enable during that phase, ip_vs_est_calc_phase() can return without installing positive limits. The kthread can then continue into its main loop and drain est_temp_list with zero chain_max, tick_max and est_max_count values. Each enqueue consumes one available tick row, but est_count never reaches the zero est_max_count value. After all rows are consumed, the row lookup returns IPVS_EST_NTICKS and ip_vs_enqueue_estimator() writes past the ticks and tick_len arrays. Exit kthread 0 after the calculation phase if the kthread is stopping or IPVS has been disabled. That keeps temporary estimators from being drained after the limits failed to initialize. Estimator kthreads can now self-exit before teardown or reload stops kd->task. Keep an extra task reference after creation and release it with kthread_stop_put(), so kd->task remains valid until the stop paths consume that reference.

In the Linux kernel, the following vulnerability has been resolved: ipvs: clear IPv4 options after rebasing tunnel ICMP errors ip_vs_in_icmp() rebases an skb from the outer ICMP packet to the quoted original request before passing it to icmp_send(). However, IPCB(skb)->opt still describes the outer IPv4 header. A timestamp option in the outer header can therefore leave an offset that points into the quoted transport header after the rebase. __ip_options_echo() treats a byte at that stale location as the option length and copies it into the fixed-size option storage on the __icmp_send() stack, causing a stack out-of-bounds write. Clear the stale option metadata after resetting the network header. Keep the remaining control block fields, including the ingress interface used by the ICMP response path.

In the Linux kernel, the following vulnerability has been resolved: packet: use consistent hard_header_len in TX_RING send path tpacket_snd() reads dev->hard_header_len independently for skb allocation and header construction in tpacket_fill_skb(). Concurrent netdevice reconfiguration can therefore make the reserved headroom smaller than the amount later pushed, or make copylen - hard_header_len negative. Snapshot hard_header_len once before processing ring frames and use it for the frame limit, headroom allocation, copy length, and skb construction. Pass the snapshot to tpacket_fill_skb(). The separate SOCK_DGRAM consistency problem between hard_header_len and header_ops->create is not addressed here.

In the Linux kernel, the following vulnerability has been resolved: net/packet: reset the MAC header on the packet-socket transmit path packet_parse_headers() resets the MAC header only for a SOCK_RAW frame whose socket did not bind a protocol. A protocol-bound SOCK_RAW socket, any SOCK_DGRAM frame, and the legacy SOCK_PACKET path therefore leave skb->mac_header unset here. For frames sent via __dev_queue_xmit() this is harmless: it resets the MAC header unconditionally. But the packet-socket PACKET_QDISC_BYPASS path uses dev_direct_xmit(), which does not, so the frame reaches ndo_start_xmit() with the MAC header unset. A driver that reads eth_hdr(skb) on transmit then dereferences skb->head + (u16)~0, an out-of-bounds access ~64 KiB past the head -- the same class fixed for one consumer in commit f5089008f90c ("macsec: do not read an unset MAC header in macsec_encrypt()"). packet_parse_headers() runs only on the transmit path, where skb->data points at the start of the L2 header for every packet-socket type regardless of its length: SOCK_RAW and SOCK_PACKET carry a user-supplied header and SOCK_DGRAM has one built by dev_hard_header(). Reset the MAC header unconditionally, mirroring __dev_queue_xmit(), so the frame is anchored on the bypass path too. Found by 0sec (https://0sec.ai) using automated source analysis; verified against source and matched to the macsec KASAN report in f5089008f90c. Compile-tested.

In the Linux kernel, the following vulnerability has been resolved: packet: synchronize pressure clearing with ring reconfiguration packet_set_ring() updates the RX ring state under sk_receive_queue.lock, but used to publish the tpacket receive mode through po->prot_hook.func after releasing that lock. packet_poll() and packet_recvmsg() can then run the pressure clearing path after the ring has been cleared while still seeing tpacket_rcv, causing __packet_rcv_has_room() to dereference stale or NULL ring storage. Move the existing receive hook assignment into the same sk_receive_queue.lock section as the ring state update. Keep the assignment otherwise unchanged, including on TX ring reconfiguration, to avoid adding behavior changes that are not required for the fix. Serialize packet_recvmsg() pressure clearing with the same queue lock only after PACKET_SOCK_PRESSURE has been observed. If the flag is clear and the socket has moved away from tpacket_rcv, packet_set_ring() has already detached the socket and waited for synchronize_net(), so no new packet input can set the flag again. packet_poll() already holds sk_receive_queue.lock, so it uses the new unlocked helper directly.

In the Linux kernel, the following vulnerability has been resolved: net: fix skb length accounting after generic XDP frag adjustment Generic XDP exposes non-linear skb fragments through an xdp_buff. If an XDP program adjusts the fragment area, bpf_prog_run_generic_xdp() copies xdp_frags_size back to skb->data_len but leaves skb->len containing the old fragment contribution. After a fragment shrink, this makes skb_headlen() larger than the actual linear area. In the reproduced UDP receive path, __skb_datagram_iter() copied 1024 bytes past the actual linear tail to userspace, starting at struct skb_shared_info. The copied bytes included the affected skb's nr_frags, xdp_frags_size and a kernel pointer from skb_shinfo(skb)->frags[0]. Real packet data was displaced by the same amount and truncated at the end. Subtract the old data_len before replacing it and add the new data_len afterwards, keeping skb->len and skb->data_len synchronized. A 60000-byte UDP datagram on a veth pair with MTU 64000 was shortened by 1024 bytes from its fragment area. Before the fix, all 10 runs produced corrupted payloads. After the fix, all 10 runs matched the expected payload exactly.

In the Linux kernel, the following vulnerability has been resolved: net: openvswitch: reallocate update replies for mismatched IDs ovs_flow_cmd_new() preallocates the optional reply skb before it takes ovs_mutex and before it knows which existing flow will be updated. That is normally fine because the skb is sized from the request flow identifier. That identifier also becomes the inserted flow's identifier. For updates, however, a request with a UFID may miss the UFID lookup and then fall back to the flow key lookup. That lookup can legitimately find an existing key-identified flow. UFIDs are optional and the flow key is the primary identifier. For echoed replies, ovs_flow_cmd_fill_info() writes the matched flow's identifier, not the request identifier used for the preallocation. A short request UFID can therefore leave too little room for the key identifier. The fill can then fail with -EMSGSIZE and hit the BUG_ON(error < 0) in the update path. Once the update target has been resolved, reallocate the reply skb if the matched flow needs a larger reply than the request identifier allowed. Do this before replacing the actions so the request can still fail cleanly if the rare extra allocation fails.

In the Linux kernel, the following vulnerability has been resolved: net/sched: reject overly deep qdisc hierarchies Deep qdisc hierarchies can lead to excessive recursion in qdisc tree walkers and exhaust the kernel stack. The existing loop check does not cover the create-and-graft path, so a hierarchy can still be extended by creating a new child qdisc below an already deep parent. Store the hierarchy depth in struct Qdisc and update it when qdiscs are grafted. Reject new child qdiscs once the parent is already at the maximum allowed depth.

In the Linux kernel, the following vulnerability has been resolved: inet: frags: publish queues before arming timer inet_frag_create() arms the fragment queue timer before inserting the queue into the fqdir rhashtable. If the namespace fragment timeout is zero or negative, the timer can run before the queue is published. The timer callback then marks the queue complete, tries to remove a node that is not in the hash table yet, and drops the anticipated hash reference. Creation can subsequently publish the completed queue without restoring that reference, leaving a stale hash node after the caller drops the remaining reference. Publish the queue first and arm the timer while holding the queue lock. This makes timer expiry wait until the queue is visible in the hash table, so inet_frag_kill() can remove the node and balance the hash reference.

In the Linux kernel, the following vulnerability has been resolved: mac802154: fix netdev use-after-free in beacon worker mac802154_beacon_worker() reads local->beacon_req under RCU and derives the sub-interface from the request, but then drops the RCU read lock and continues to use both sdata and the embedded wpan_dev. mac802154_stop_beacons_locked() cancels only pending beacon work, clears local->beacon_req and frees the request. A beacon worker that is already running can therefore continue after interface teardown and dereference the freed netdev private area. The scan worker already pins the netdev before leaving RCU. Apply the same lifetime rule to the beacon worker: take a netdev reference while the request is still protected by RCU, and release it on all paths that continue after the reference is acquired.